Lost contact contact with the smartarray 6400 & Intel 1000 pro MT.
Even the built in nic is no longer configurable from C-A-N.
So before anything else is there a "local" possibility to rescue the config on the adapter?
Usb drive ide disk?
Have a open case with support but any advice would be appriciated!
You can try to reflash with the ISO for the version that you have. Also try to hit the Escape key after POST then select Rescue mode to see if this enables the NIC's and Controller. Are these NIC's built into the Motherboard??
The iso thingie seem litlle scary!
Tried the rescue mode a new dimension but no difference to the problem!
The nic is one internal and two extra card pci-x connected.
The problem is that from C-A-H the hardware is "system aware" but no one of the nic card are available from C-A-N to enter a ip address.
The C-A-N gives only possibillity to change DNS settings and this is no help what so ever.
What is your current version now? Did you save your resoureces in Maintenance > Miscellaneous? If you did then you can just load them back after reflashing with 1.72.
Checking for saved configs i see that we created folders for it on one server.
But no files there....
So this is not god no god config backup and data that is important not reachable.
Cant reallly lose the two virtual machines that are on this config so.
Any help.
I have another adapter where on the adapter are the config file located is there possibillity to move them by hand in other enviorment?
Have you tried to drop the server down then reseat the RAID controller then restart it again?
You can reflash the module with 1.72 w/CDROM, but you will most likely have to change IP and password back to what you had originally.
Newbie
Rescue config from server console?
Posting Permissions
Reply With Quote