Hardware

[gharding]

I can confirm that using the external cable I habve got our servers booting from the usb module no need for the cd-rom just make sure in the BIOS that under the usb you set it to be looking at the DOM and config your boot order. And that should work.

Gavin

[To-M]

Gavin,

1.30 is now released - please read the release notes.

As always great to have your input

[Klug]

Todd, where are the release notes ?
I did not found them on the website...

[To-M]

Open-E iSCSI-R3 Enterprise Release Highlights:
* 2007-07-03 ver. 1.21 release
NEW FEATURES:
· License Key Support,
· Motherboard status via SNMP,
· Routing table management,
· Support for Crystalfont LCD panel.
UPDATED DRIVERS:
· 3WARE drivers ( v9.4.1 ),
· Intel NIC e1000 ( v7.4.27 ),
· Myricom NIC 10Gb ( v1.3.0 ),
· Adaptec RAID driver ( aacraid v1.1-5[2442] ),
· Promise RAID driver ( v3.0.0.1),
· Support for Broadcom NetXtreme II BCM5706/5708 Driver ( v1.4.45 ),
· Support for Adaptec aic94xx SAS/SATA driver ( v1.0.2 ).
FIXED
· Online update functionality.
KNOW ISSUES:
· Online update do not work with Open-E iSCSI-R3 v2.10 b2566. In such a case please
use CD update,
· Online update is not keeping the SNMP settings. After updating please reconfigure
SNMP functionality,
· When using 64bit system mode there is limitation to 1 active snapshot per LV and 10
active snapshots overall.

[Klug]

Thank you, however these are 1.21 release notes 8)

[To-M]

Correct and this section of the forum is for iSCSI-R3 so latest release notes is for 2.21.
If you need 1.30 release notes let me know, as I do not want to post DSS release notes in iSCSI-R3 section. Email me at todd.maxwell@open-e.com and I will send them.