Replication

[To-M]

That is strage especially if it was working, is the V-Rep NICs on the same subnet for 10.100.2.23x? Are you running any VLANs?

[gharding]

Yes they are on the same ip network and no vlan, they can also ping each other. If i create new volumes on SANS and use A as the source and B as destination I can create a replication task just not the other way around

[To-M]

I tested it on my servers here in the lab and works for me, is there some events that took place that you post? Is this a production server or test server, if test server I could take a look over a Netviewer session.

[gharding]

The servers are in production, but only server A serves out volumes at the moment. Ok so i went on to SAB B and disconnected the Host binding and it removed all the replication tasks on both servers. I then setup the remote ip address and it connected ok. I can now create replication tasks both ways, maybe the password or something became corrupt, not sure but seems ok now. Will know for sure once all the replication is in sync and i try again

[To-M]

The password would hav an effect if it was changed, if you think it could be currupted that would be in the system volume.

[gharding]

It seems to be working ok now , i have carried a manual failover on a test vm and volume and seems to work correctly and allows the reverse sync to work as well. Must the admin password be the same on both DSS servers for the GUI, as I am not sure what could of caused the problem, we did have some power issues here a couple of weeks ago so maybe something happened then.

[To-M]

If it changed it can be a problem.