The fuction to deny and/or allow access to specific IP addresses or ranges. It does not let you enter multiple entries.
The instructions show that multiple entries are supposed to work, and to delinate them with a comma. But putting in more than one in either the deny or allow list will show an error "Allow list contains Invalid IP/Mask".
LOL. Actually I was wrong. Entering multiple single addresses appears to work in the deny list. However, it doesn't actually deny any of them. It only works when a single entry is put in there (which doesn't help me).
Play around with it, and actually check to see if it is allowing or denying what it says. The whole thing is screwed up.
You are correct I have the same issue with the following. Not many people use this and researching the database never really came up with anything. Thanks for the research and sorry for the frustration. I checked with engineering and not sure if there will be an update to this - no set time table.
The thing is I ditched my swich and removed all the NIC bonding. Basically, I have two NICs per client. So now I am having two targets (one for each NIC) and striping them with software on the client end.
The problem is my initiator doesn't allow me to pick which NIC to use for which target. The only way to make it work properly is to block the relative IP addresses from the target.