I saw in the release notes for update 7.0up12.9101.10529 that there was a mention of Virtio so I thought I would try it out since I have been very eager for this feature.
When I boot it and go to Status->Hardware I see:
Controllers Info
- Network controllers
- Red Hat, Inc Virtio network device
- RAID/SCSI controllers
- Red Hat, Inc Virtio block device
Drivers Info
- Network drivers
- Virtio network driver
- RAID/SCSI drivers
- Virtio SCSI HBA driver
However, while the network adapters show up just fine I can not get it to recognize a virtio hard disk.
Is there a trick that I am missing?
Thanks.