We have an Active-Active DSS7 installation at work using two HP 380p Gen 8 rack servers as data nodes and multi-path iSCSI over 10GbE to a two-node Hyper-V cluster.
It works great!
I'm building a lab on the side to test features and situations, and purchased HP Gen 8 Microservers. These models have B120i Smart Array controllers which I enabled through RBSU and confirmed were the primary controller. I exited setup, restarted, and used the HP RAID utility (F5) to join my two 1-TB physical disks into a RAID 1 Array. I created a 2GB logical drive and another logical drive with the remaining space.
Upon trying to install DSS 7 with the available ISO, I reach the point where I choose a volume and it presents me with my two 1-TB physical disks rather than the 2GB and 998GB logical drives.
The RAID controller posts properly and the RAID configuration looks good via iLO4.
Any help?