Error binding hosts

[SamB]

We previously (earlier today) had a semi working Active/Passive setup using two infiband networks and a 1gb management network.

However, due to an issue we were having with failover, we had to remove everything we had done and start again.

However, after removing the host bindings, i can no longer bind the hosts. I receive the error "Too many bound hosts on remote host." - there are no hosts bound to either of the DSS systems. All replication tasks have been removed, all settings in the Failover configuration have been removed and we have re-created the iSCSI volumes and also rebooted both hosts.

Has anyone come across this and fixed it? It's a POC for a huge project we're working on internally and would really like to prove this software.

Thankyou.

[Gr-R]

It sounds like a configuration file has become corrupted somehow during all the changes.
From the console CNTRL+ALT+X menu, return to the factory configuration and reboot.

[SamB]

Hmm ok.

Will I lose the network settings?

[Gr-R]

You shouldn't. That is part of the 'Restore to factory network settings' option in the same menu.

[SamB]

Ok, I've done that. Still experiencing the same issue.

[Gr-R]

Interesting!
Try then running the file system repair from the same console menu.

[SamB]

I see "Repair Filesystem on LV (Logical Volume)" - is that the option I need?

[Gr-R]

yes, that is correct