Visit Open-E website
Results 1 to 2 of 2

Thread: How to set MTU?

  1. #1

    Default How to set MTU?

    When editing network interfaces in the software, I can't figure out where to change the MTU settings on the interfaces from the GUI or the console.

    I'd like to set the MTU to 9000 to match the interface config on ESXi hosts and switches.

  2. #2


    This can be done in the Console screen. Enter the following in the Console screen CTRL ALT W then select Tuning options then select Jumbo Frames Config.

    More about setting the MTU values for your NICs is in our KB article below.
    All the best,

    Todd Maxwell

    Follow the red "E"
    Facebook | Twitter | YouTube

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts