Okay great thanks.
How can I roll back.
Thanks
Okay great thanks.
How can I roll back.
Thanks
In the GUI go to Maint. > Software update then click on the last build that it was using and reboot. If there is none then go to your User Portal on our site and download the previous build and upload it in the same GUI location and reboot.
Okay thanks,
What is the correct method for rolling back.
Thanks
As I stated before just go to the GUI in Maint. > Software update then click on the last build that it was using and reboot. If there is none then go to your User Portal on our site and download the previous build and upload it in the same GUI location and reboot.
Ah yes sorry, I had not seen your post before posting a new message.
I will try that and report back.
Many thanks
Hang on, I cant.
This is the base version.
Does that mean a reload using an older kernel.
I will send you the link for the previous build in your inbox, download then update then if your in Failover move the resources over to the other node then reboot and test, if you want you could move the resources back and the others from the other node and update that one as well then reboot and put back the resources and test.
Nope, HP SMart Array P420I.
Yes that returns same as hpacucli ctrl all show config detail
*-----------------------------*
hpacucli-start ctrl all show status
*-----------------------------*
Smart Array P420i in Slot 0 (Embedded)
Controller Status: OK
Cache Status: OK
Battery/Capacitor Status: OK
*-----------------------------*
hpacucli-start ctrl all show config detail
*-----------------------------*
Smart Array P420i in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0