DSS v7 up50 - slow cluster performane with 10Gbe

[Tommy]

RAID: HP P420/2GB BBWC, 2x 200GB SSD SmartCache

After tweaking initiator its better, but it could be more. In compared to degraded cluster.
"1073741824 Bytes (1,1 GB) kopiert, 4,77698 s, 225 MB/s"

[Gr-R]

you may want to check how the caching is set on the raid. If I recall correctly, you may set different percentages for read or write on the card.

[Tommy]

yes, you're right. 70% read / 30% write

[Gr-R]

you might try different cache values based on your testing.
balance-rr is the least sophisticated bond, this should not be a problem.

[gharding]

I have a similar issue and from all my testing it points to the replication that causes the performance decrease. I have tried making changes to the replication but cannot improve the performance. I have tested all the 10GB cards using the network test and all tests correct. Eg running iometer replication off /cluster degraded i get RX 1900MBs WR 1800MBs, when cluster normal RX 1250MBs WR 700MBs

[Gr-R]

Replication can have a impact on performance. This typically can be mitigated by making sure raid caching is working, and is large enough.
In the current releases, the bandwidth is dynamically allocated for each task. This and other tweaks can be done to the replication module:
http://kb.open-e.com/Tuning-recommen...1GbE_1603.html (applies to 10GBe also).