NIC Bonding 802.3ad troubles

[Inssomniak]

Check the tests.log from the log file and check the ifconfig -a section and see if the MAC Addresses are the same.
Also go to the Console screen and enter CTRL ALT N then change the Gateway there to see if holds.

Attached output: Looks OK to me..

*-----------------------------------------------------------------------------*
ifconfig -a
*-----------------------------------------------------------------------------*

bond0     Link encap:Ethernet  HWaddr 02:A1:82:A5:4A:A6  
          inet addr:172.16.122.7  Bcast:172.16.122.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MASTER MULTICAST  MTU:1500  Metric:1
          RX packets:180330287 errors:0 dropped:4079 overruns:0 frame:0
          TX packets:1086776746 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:140435067664 (130.7 GiB)  TX bytes:1563664401741 (1.4 TiB)

eth0      Link encap:Ethernet  HWaddr 02:A1:82:A5:4A:A6  
          UP BROADCAST RUNNING SLAVE MULTICAST  MTU:1500  Metric:1
          RX packets:113362483 errors:0 dropped:3 overruns:0 frame:0
          TX packets:20206 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:67549137372 (62.9 GiB)  TX bytes:2546433 (2.4 MiB)

eth1      Link encap:Ethernet  HWaddr 02:A1:82:A5:4A:A6  
          UP BROADCAST RUNNING SLAVE MULTICAST  MTU:1500  Metric:1
          RX packets:66967804 errors:0 dropped:6 overruns:0 frame:0
          TX packets:1086756540 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:72885930292 (67.8 GiB)  TX bytes:1563661855308 (1.4 TiB)

ipddp0    Link encap:UNSPEC  HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00  
          BROADCAST NOARP MULTICAST  MTU:585  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:17819334 errors:0 dropped:0 overruns:0 frame:0
          TX packets:17819334 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:3175395494 (2.9 GiB)  TX bytes:3175395494 (2.9 GiB)


*-----------------------------------------------------------------------------*
route -n
*-----------------------------------------------------------------------------*

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
0.0.0.0         172.16.122.1    0.0.0.0         UG    0      0        0 bond0
127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 lo
172.16.122.0    0.0.0.0         255.255.255.0   U     0      0        0 bond0
172.16.122.1    0.0.0.0         255.255.255.255 UH    0      0        0 bond0

*-----------------------------------------------------------------------------*
ip route
*-----------------------------------------------------------------------------*

[Inssomniak]

Couldn't figure out how to edit a post, but you can see that the server receives evenly the data, but eth1 has done all the transmitting.. I can't use the local console because its off site, any other way to set that gateway from eth1 to bond0 without driving there (and if I recall, the console showed the correct gateway anyway)

Thanks!