Demo CD not working

[secdes]

I have downloaded the NAS-XSR demo - File demo_54.20060822.308.b2137.xsr-ent.iso

Prob 1 - If I try to burn the iso to disk on windows I get an error. I can burn it on linux. - is there a problem with this iso ? I get the same result using the demo_18.20060111.180.b1410.nas-ent.iso and demo_10.20060309.300.b1654.xsr-smb.iso Iso's


Prob 2 - Using the burn from linux I boot the server (the same server will boot the iscsi-ent demo cd) it hangs at the Open-e graphic and will not continue from there.

Any Ideas?

Thanks

[To-M]

Prob 1:

Please verify the download file size and MD5 check are correct.

For NAS-XSR Enterprise 270.MB.

demo_54.20060822.308.b2137.xsr-ent.iso 270.0 MB
demo_54.20060822.308.b2137.xsr-ent.iso.md5

Try to set the CD burning file system properties to use ISO9660.

Prob 2:

This could be caused by system resources. The necessary hardware requirements are as follows:

- 1 GByte RAM
- CPU ( 2,8 GHz or faster)
- Ethernet card
- IDE Port

Also please review our site for product compatibility listings.

http://www.open-e.com/data_storage_s...bserv=prodcomp

[secdes]

I redownloaded the file and while it says its downloading a 270MB file I only get 146MB

I checked the MD5 key and its different.
key for one downloaded is 6decec04537927c562a530981c8f533

The system is a Xeon Dual core, 2Gb Ram, Dual 1Gb Intel Nics, Supermicro MB with IDE and 3ware 9550 16 port SATA Raid

If you can give me a direct link to the download I will try it

[To-M]

I will check this out to see if there is an issue and get back to you today on this. Please try again sometimes there might be some routing issues.

[To-M]

I wanted to follow up with you on the download issue. I experienced the same problem as well. I would suggest trying again later, as work is being done on the server or there could be a temporary routing problem.

[secdes]

I was able to get it downloaded - Now when it boots I don't get an option to change the network cards. This Motherboard combo worked great for the iscsi cd. I have the supermicro x7dbe-o board with 2 onboard intel gig nics. The hardware display at the console show 2 Intel 631xESB/632xESB DPT Lan Controller Copper Rev (1) nic's

Any Ideas?

[To-M]

This will also be updated in our next release from the Supermicro X7DVL-E-O
and the Supermicro X7DVL-E-O motherboard as we are seeing more of these in the market. You are definitely working on all the hits!
We appreciate this kind of due diligence.
Thank you!

[secdes]

So should I wait for an updated build?

[To-M]

I would and for other ideas I would contact the North America support line - you will reach a human speaking engineer (770) 881-7680 .

[To-M]

I have an update for your Supermicro on the NIC issue. Please email me at todd.maxwell@open-e.com so I can send this to you.