some general questions..

[Raudi]

I think the bottleneck woll be the harddrives not the CPU...

A few days ago i made a migration of 6x 750GB to 8x 750GB and this takes nearly one week to rebuild. Perhaps a rebuild after a drive failure is faster than a migration... Until now i didn't had a drive failure.

Best regards
Stefan

[warmduscher]

Hi Raudi,

what kind of controller do you use?
we had similar problems with 3ware products (eg 9550), on high IO situation the r/w performance dropped down to constant 8MB/s for minutes, then rising again for some time, again dropping...

so we switched from 3ware with raid5 to areca raid6 and we noticed a massive perfromance gain compared to 3ware, even with raid6!

regards,

lutz

[To-M]

Found others having issues with performance on the 3Ware 9550 as well, not sure if this will help in your incase but others claimed it did when they updated to latest.

http://www.3ware.com/KB/article.aspx?id=14956

[warmduscher]

Hi Todd,

thanks for that interesting info. a little bit too late for us, we switched to areca mid 2006 :-)

Regards,
Lutz

[SuperSAN]

Hi warmduscher,

Please update us when you run tests with 2x quadcore vs. 2x dualcore xeons. Lets us know

[Raudi]

what kind of controller do you use?
we had similar problems with 3ware products (eg 9550), on high IO situation the r/w performance dropped down to constant 8MB/s for minutes, then rising again for some time, again dropping...

I use a 3ware 9550SXU-16ML... This sounds not good, but i hope the issue is fixed. Uses here someone a 3ware too and can tell his experience?

Regards
Stefan

[Robotbeat]

We used a 3ware 95xx series card (first half of 2007), and we had horrible performance. We also switched to an Areca controller.

[netsyphon]

we use 9650 controllers and have no problems.

if i could go back however i would have bought Arcea.