-
No GUI Access after Sofware Update
Hi,
today I updated the DSS by using the online update service to 1.37. After the installation I clicked the reboot button and waited few minutes. Now, I can't access the GUI any more. The IP before the update was 192.168.0.1. I still can ping the server and that adress, it's there and I still can access the share folder. But the GUI is not available at 192.168.0.1 any more.
Any ideas?
Thanks
Paul
-
mmm... interesting...
Did you try to open it from Firefox? It happened to me before..Also check the IP, it may send it back to the default when you make the update.
-
No chance from any browser. I can ping the server on 192.168.0.1. On the default 192.168.0.220 and 192.168.1.220 there is no response.
The share is still accessable, I can deal with the data on it.
-
Are you using certificates? If so you can reset them from the Console Tools CTRL + ALT + T then select "Time Configuration" just take the defaults to the end. If that does not work then reset the network settings again in Console by entering CTRL + ALT + I then go back and change your IP Address, Subnet, Gateway and DNS (If need be) by entering CTRL + ALT + N. Does this happen with other systems from the network as well?
All the best,
Todd Maxwell
-
OK, I got it. It was the installed certificate in IE from open-e. It seems that the old certificate was not the same as after the software update. But IE only showed that the page couldn't be found.... Very strange.
Paul
-
But now I have another problem...
After the update, I have problems with the error message functionality. I can see that there are any messages, but when the message window opens, I can't see anything there.
Any ideas?
Paul
-
Are you using I.E. or Firefox ?
All the best,
Todd Maxwell
-
IE...
That's why I had the other problem above, too.
Paul
-
-
With Firefox I can see the messages...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules