Hello,

i wrote already that i have the problem with the "No Cable", but now i installed the current RC (or Beta? Ver. 2956) and in the "Setup / Fibre Chennel" the DSS told me that there is no FC HBA.

After upgrade the Kernel is switched back to 32 Bit, so i changed it to 64 Bit but then the controller will be shown in "Status / Hardware" but not in "Setup / Fibre Channel".

Has anybody some ideas?

I will try what happens when i switch back to 32 Bit and then back to Initiator mode, if i remember right i switched to Target mode with the 32 Bit kernel. Perhaps i must change this when the 64 Bit kernel is running... I tested already with the normal kernel and with the testing kernel.

Best regsrds
Stefan