webgui with blank screen

[HofMar]

I've tried it from other systems, too. It's not a problem from a firewall or a popup blocker. I use a clean firefox installation with no plug-ins!

Pings from outside are replied. From Inside i don't tested it. I do it later.

I think the reset from the certifitate have a done when i look for the correct time settings. He ask me about. I have also tried the "factory default settings".

[To-M]

Just to make sure I understand correctly you are installing Open-E DSS lite in a VM?
If so can you please test DSS LITE by itself without VM.

[HofMar]

Yes, i've installed Open-E DSS lite in a VM. At this moment i can't test it without VM. Is there a problem to run in a VM?

[To-M]

It may very well be the issue as we have not tested this within a VM. Even in our professional versions this will not work.

[pebras]

I have a similar problem with the Open-E DSS lite just like HofMar. The installation on an USB-Stick, the configuration of the IP-Address, Pings from outside/inside and the console don't cause any trouble, but if I try to connect on the webgui with https, it only shows a blank screes after accepting the certificat.

This occurs on Windows as well as on Linux with all kinds of Browsers (Firefox, IE, Opera, etc.)

[To-M]

I don't have a VM system yet, but can you test this without the VM, only just using the DSS LITE just to test. I have a VMware server and I was not able to do this DSS LITE only with the Demo-CD. Also are there any errors on the bottom left side of the screen - showing a red exclamation mark?

[idicos]

Athlon with VIA Chipset, 5 HDs, detected perfectly, 2 Network Cards, both detected perfectly. Console just fine. But no WebGui. Neither card is working though. Tried "reset cert" already. Too sad...

Regards,
Mike

[boerie]

I have the same problem. Console ist running fine. 192.168.0.220 ist listed in the routers connected devices. Ping works fine. When calling http or https the system ist asking to accept the Certificate. After that, blank page with no Source code at all is displayed.

I have installed NOT in VM but on a IDE2CF Converter, as Salve Device on primary IDE Controller.

[pebras]

The installation is on an USB-Stick, there is no VM. The webgui screen is blank and no errors or red mark.

[firesl]

I also have the same Problem.
The installation is on a local HDD and the console works very well.
I can Ping the Server but if I try to connect on the webgui with https, it only shows a blank screen after accepting the certificat. (Firefox and IE)