webgui with blank screen

[pebras]

I have a similar problem with the Open-E DSS lite just like HofMar. The installation on an USB-Stick, the configuration of the IP-Address, Pings from outside/inside and the console don't cause any trouble, but if I try to connect on the webgui with https, it only shows a blank screes after accepting the certificat.

This occurs on Windows as well as on Linux with all kinds of Browsers (Firefox, IE, Opera, etc.)

[To-M]

I don't have a VM system yet, but can you test this without the VM, only just using the DSS LITE just to test. I have a VMware server and I was not able to do this DSS LITE only with the Demo-CD. Also are there any errors on the bottom left side of the screen - showing a red exclamation mark?

[idicos]

Athlon with VIA Chipset, 5 HDs, detected perfectly, 2 Network Cards, both detected perfectly. Console just fine. But no WebGui. Neither card is working though. Tried "reset cert" already. Too sad...

Regards,
Mike

[a93h201]

I too am having an issue with DSS lite

Iomega NAS P410
Duel Intel 100 Pro NIC
1GHz PIII
512MB
4x 120GB ATA HDD
1x 4GB Samsung CF 150x in IDE CF adapter

Boots and pings from console, but wont connect from HTTPS just a blank page

There is an error on statup to do with the change.img something about not being able to load it in to memory

[To-M]

Try increasing the Hardware Requirements:
- x86 - compatible PC
- 1 GByte RAM
- CPU (3 GHz Pentium IV or faster are recommended)
- HDD (SATA, SAS, SCSI, ATA) / RAID / Fibre Channel / iSCSI Storage
- Network Interface Card (multicards 1Gb/s recomended for bonding)
- USB-Memory-Stick, USB-DOM (Disk On Module) or "pen drive"

http://www.open-e.com/free

[boerie]

I have the same problem. Console ist running fine. 192.168.0.220 ist listed in the routers connected devices. Ping works fine. When calling http or https the system ist asking to accept the Certificate. After that, blank page with no Source code at all is displayed.

I have installed NOT in VM but on a IDE2CF Converter, as Salve Device on primary IDE Controller.

[boerie]

forgotten to post the System:

Bank webgui for a system:

FSC Scaleo
CPU P4 2 GH
1,2 GB RAM
80 GB WD IDE As Master on IDE0 as Master
IDE2CF Converter as System Device on IDE as Slave

So I met the hardware requierments. (altough I can not imagine that having an 1 GH processor keeps the system from working...)

[To-M]

Check Date and Time - maybe certificate was generated for WebGUI and is not valid for your time settings.

[Fitz]

I have the same problem, that the webGUI doesn´t show anything.

could their be a different download?
I have read about 2TB limitation. Can someone give me a link to this download?

thanks,
Fitz

[pebras]

The installation is on an USB-Stick, there is no VM. The webgui screen is blank and no errors or red mark.