Visit Open-E website
Results 1 to 2 of 2

Thread: Simple questions

  1. #1

    Default Simple questions

    1. The manual indicates that there is a command line interface to iCSCI-R3, but if my reading of pages 28-29 is correct, it appears to be limited to setting a few configuration parameters and can not be used to say, control client access to a target. Is this correct?

    2. It appears that client access to targets is controlled by IP address and not iSCSI initiator ID. Is this correct?

    3. Assuming the initiator supports it, is iSCSI boot supported?

    Thank you!
    DL

  2. #2

    Default

    Q1.> I think it means CLI to use with RAID tools or FC HBA's CTRL ALT R or F

    Q2.> Yes, Allow/Deny or CHAP is all controllered by the IP add.

    Q3> If you are using INtel NIC, then you can use the remote boot

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •