WebGUI not accessible

[SuperSAN]

I know Open-e support always recommend using Firefox... and actually both of them are working for my end...
Check if there is any blocking... check your certification.. Try from a different system and see if you can access the GUI.....

you can run the update one more time and flush the DOM.. it will not affect ur data.. but its good to save you setting before.. this option is in the Maintenance tab then Misc.

[Pascal]

I've tried to access the GUI from 3 different systems, both with IE and FF. But same result: no access.

Saving my settings before flashing again is a problem as I can't access the GUI and therefore can't reach the Maintenance tab.

Any other suggestions would be greatly appreciated.

[To-M]

Try to go in the Console Tools and access the Time configuration and accept the defaults.
You can also try to use Rescue mode to access the system. After POST from system booting up enter the "Escape or Tab" key to enter a basic grub menu then select th Rescue mode option. See if you are able access the GUI then. Try to direct connect to the system without switch.

[Pascal]

Regrettably none of the suggestions have helped.
When I select the RESCUE MMODE I get the following message: "Your CPU does not support long mode. Use a 32bit distribution." In the basic grub menu I've selected 32bit, but that has the same result.

[Lucky]

Have you try it on other hardware ??

[Pascal]

Don't have any other hardware to try it on, regrettably....

[DSSpower]

Have you already checked you cabling and your ethernet configuration.

Maybe on your switch are some ports blocked or something like that. Just try to use a simple network area.

Server - Switch - OpenE