Trying to create an iSCSI-cluster with Version: 5.0.DB47000000.3117 wo do have the following problem:
setup - network - iSCSI Cluster
Secondary
Here we can create a Secondary Cluster Member but the status is always:
- Service running inactive
- Node status inactive
- Ping node disabled
- eth3 unknown
- com 1unknown
We are not able to add the reverse iSCSI Target to the Cluster Task (Button grayed)
- No task have been selected.
- In secondary mode start and stop action will be made only on this node.
Primary
Here we can create a Primary iSCSI Cluster Meber with following Status
- Service running inactive
- Node status inactive
- Ping node ok
- eth3 unknown
- com1 unknown
We are not able to add the reverse iSCSI Target to the Cluster Task
Error: Most probably there has been an error when connecting to the other node, or one of the selected tasks does not have a counterpart (a reverse task) on the other node. Please check the secondary node address and make sure you have configured appropriate reverse tasks.
- Info No task have been selected
Whats going wrong
- Both DSS do have an virtual IP with the same address
- there is an iSCSI Volumne successfully replicated
- both servers do have the iSCSI target with same name
regards Stefan