Trying to create an iSCSI-cluster with Version: 5.0.DB47000000.3117 wo do have the following problem:

setup - network - iSCSI Cluster

Secondary

Here we can create a Secondary Cluster Member but the status is always:
- Service running inactive
- Node status inactive
- Ping node disabled
- eth3 unknown
- com 1unknown

We are not able to add the reverse iSCSI Target to the Cluster Task (Button grayed)
- No task have been selected.
- In secondary mode start and stop action will be made only on this node.


Primary

Here we can create a Primary iSCSI Cluster Meber with following Status
- Service running inactive
- Node status inactive
- Ping node ok
- eth3 unknown
- com1 unknown

We are not able to add the reverse iSCSI Target to the Cluster Task

Error: Most probably there has been an error when connecting to the other node, or one of the selected tasks does not have a counterpart (a reverse task) on the other node. Please check the secondary node address and make sure you have configured appropriate reverse tasks.

- Info No task have been selected

Whats going wrong
- Both DSS do have an virtual IP with the same address
- there is an iSCSI Volumne successfully replicated
- both servers do have the iSCSI target with same name

regards Stefan