- I named the targets equal
- I set up the Virtual IPs on my NICs on both Systems
- the Auxilary is set on all NIC

the status on the primary:
Code:
Names  	Status
Global status
  	Service running 	inactive
  	Node status 	inactive
  	Ping node 	    ok
Communication via:
  	bond1 	unknown     (192.168.6... - replication)
  	eth2 	unknown    (192.168.10.... - iSCSI )
  	bond0 	unknown   (192.13.47.... LAN)
- the ping node: 192.13.47.xxx
- I entered the IPs from the replication bond as primary and secondary nodes.


but when I activate a iscsi-task for failover I´ll get an error:
Most probably there has been an error when connecting to the other node, or one of the selected tasks does not have a counterpart (a reverse task) on the other node. Please check the secondary node address and make sure you have configured appropriate reverse tasks.

On the secondary I could not setup a replication task, because the Volumes are in target-mode.

So whats wrong?