Thought I would throw up a possible fix, to complete this thread....

I was having the same problem adding new targets - all seemed well except that I couldn't get my hosts to connect to them. It was frustrating me, and got added to the "something I will deal with when I have time/must do" list.

I just realized that the volumes were setup in the volume replication section as destinations, not as a source. I changed it to source, rescanned the box, and low and behold it found it connected to the target without incident.

The sad thing is that there is even a warning message that shows up about it, but at the time I was dealing with it, I had much bigger fish to fry and apparently didn't read the warning.

Take care,
Rick