Ok, now i have brought two Emulex FC HBA.
But the OPEN-E DSS V6 is not reconizing it, why?
Ok, now i have brought two Emulex FC HBA.
But the OPEN-E DSS V6 is not reconizing it, why?
And i was using DSS V6 trial!Originally Posted by m.casco
Thanks for the quick reply!
I have uninstalled the DSS V6 Trial now, but the message that was on screen was:
- Configuration -> FC Target Manager:
Warning: No Fibre Channel Host Bus Adapter found. All Groups and HBAs settings will be saved but will have no functionality until you plug in appropriate HBA card.
- Status -> Hardware:
Fibre Channel controllers
Emulex Corporation LP1150 Fibre Channel Host Adapter
The funny thing is that the software says EMULEX in "Setup > Fibre channel"
AND!
In the software comparsion chart says Donīt suppor MULTIPLE FC not for one.
Thanks!!
OK.
Fresh install, here are the logs:
http://descargas.fiesa.com.ar/descar...rios/TRL00022_[5087]_logs_2011-02-15_21_31.tar.gz
Please confirm, can i use at least one single FC card on DSS V6 Lite?
Thanks!!!
We dont provide FC support for the Lite product only the Full Version.
In the logs I do see the Emulex and we are loading it so it can be used as an initiator but not as a Target.
Emulex LightPulse Fibre Channel SCSI driver 8.2.7
Copyright(c) 2004-2008 Emulex. All rights reserved.
lpfc 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
lpfc 0000:01:00.0: setting latency timer to 64
scsi5 : on PCI bus 01 device 00 irq 16
OK To-M, thanks for your support but at present, DSS V6 is not an option to me.
OK, now i have one more chance to use OPEN-E DSS V6.
The QLogic QLE2462, is compatible with the DSS V6 in target mode?
Thanks!!