Did the RAID complete the migration for the size? If so then please send in the logs to support@open-e.com so we can see what is happening. What RAID controller is it?
Did the RAID complete the migration for the size? If so then please send in the logs to support@open-e.com so we can see what is happening. What RAID controller is it?
The raid controller is an ARC-1680 and the controllers reports complete on the array expansion moreover: the volume manager reports 11000Tb.
Hello,
we have the same issue with a 3Ware 9650-SE 12-port Controller. We had 6x1TB in a RAID 6, added 3x1TB, waited for the controller to finish the resize and then did the pv resize. Now i see 6519GB in the volume manager, but cannot assign the space to the existing logical drives nor can i create new drives - the slider is just fixed. Same after 2 reboots.
Is there any solution to this?
Send in a request to support@open-e.com with logs and and ask for remote support - i want them to look into this.
Any update on this one, as we have just seen the same thing on a LSI MegaRaid controller.
It took a couple of reboots (after the pv resize) just to get the new size to report correctly in Unit size, but as above posts, free space is still incorrect. I have submitted logs to support anyway (Ticket#1010974), this post is just say it's not a 3ware etc. Raid controller-specifc issue. Cheers.
I have the very same issue here.
A disk was added to the array and with some console command I was told to run, the total volume space reflects the new size. However the sum of the used and free space still add up only to the previous volume size.